Surface Method · MPI / MT

Magnetic Particle Inspection

Reveal surface and near-surface discontinuities in ferromagnetic parts using wet fluorescent and dry visible magnetic particle techniques.

Overview

What is Magnetic Particle Inspection?

Magnetic particle inspection detects surface and slightly subsurface discontinuities in ferromagnetic materials. When a magnetic field is induced in the part, a flaw distorts the field and creates a leakage flux that attracts iron particles, forming a visible indication directly over the defect.

Gulf Coast NDT performs both wet fluorescent magnetic particle examination — for maximum sensitivity to fine, tight cracks under UV-A light — and dry visible examination for field and heavy-fabrication work. We magnetize with yokes, prods, and coils to suit the geometry, and every job is performed by technicians certified to ASNT SNT-TC-1A Level II or III.

Capabilities

What MPI / MT Delivers

  • Surface fatigue and service cracks
  • Weld cracks, lack of fusion open to the surface, and undercut
  • Near-surface porosity and inclusions
  • Seams, laps, and grinding cracks
  • Quench and heat-treatment cracks
Our Process

How It Works

Clean & assess

Prepare the surface and select the magnetizing technique for the part's geometry and material.

Magnetize

Induce the field with a yoke, prods, or coil, orienting flux perpendicular to expected defects.

Apply media

Apply wet fluorescent or dry magnetic particles as the field is applied.

Inspect & demag

Interpret indications under UV-A or white light, document, then demagnetize the part as required.

Where It's Used

Applications

  • Weld inspection on structural steel and pressure equipment
  • Crane hooks, lifting gear, and rigging
  • Drill pipe, tool joints, and oilfield tubulars
  • Castings, forgings, and machined components
  • In-service crack surveys during turnarounds
Equipment & Standards

Techniques, Equipment & Standards

We match magnetizing method and particle type to your sensitivity requirement, and follow the applicable code for acceptance and documentation.

  • Wet fluorescent & dry visible techniques
  • Yoke, prod, and coil magnetization
  • ASTM E1444 / E709
  • ASME BPVC Section V, Article 7
  • AWS D1.1 weld acceptance

Need Magnetic Particle Inspection?

Tell us about your project and we'll get you a fast, no-nonsense quote.