Material Verification · HT

Hardness Testing

Verify material strength, heat treatment, and PWHT integrity with portable and laboratory hardness methods — in the field or in the shop.

Overview

What is Hardness Testing?

Hardness testing measures a material's resistance to permanent indentation, giving a fast, reliable proxy for tensile strength, wear resistance, and the success of heat-treatment or post-weld heat treatment (PWHT). It is essential when material certs are missing, when weld procedures must be validated, or when in-service degradation is suspected.

Gulf Coast NDT brings the right method to the part instead of forcing the part to a bench. We use conventional Brinell approaches such as TeleBrinell and Pin Brinell alongside modern portable instruments — Equotip Leeb rebound testers and Ultrasonic Contact Impedance (UCI) units — for accurate readings on everything from large weldments to finished, machined surfaces.

Capabilities

What HT Delivers

  • Confirmation of heat-treatment and PWHT hardness limits
  • Weld and heat-affected-zone (HAZ) hardness surveys
  • Verification of material strength where certs are missing
  • In-service hardening or softening from process exposure
  • Incoming material and positive-property checks
Our Process

How It Works

Method selection

Choose Brinell, Leeb rebound, or UCI based on part size, geometry, surface finish, and the governing spec.

Surface prep

Lightly prepare the test spot so surface condition does not skew the reading.

Measurement

Take multiple indentations per location to produce a statistically sound average.

Conversion & reporting

Convert to the required scale (HB, HRC, HV) per ASTM E140 and issue a documented report.

Where It's Used

Applications

  • Post-weld heat treatment verification
  • Sour-service (NACE / hardness-limited) compliance
  • Pressure vessel and piping weld surveys
  • Failure analysis and material confirmation
  • Incoming quality control
Equipment & Standards

Methods, Equipment & Standards

Portable Leeb and UCI instruments let us test in any orientation and on finished surfaces, while conversions follow recognized standards so results are traceable and defensible.

  • TeleBrinell & Pin Brinell (comparison Brinell)
  • Equotip Leeb rebound testers
  • Krautkramer MIC 10 / MIC 20 UCI testers
  • ASTM E110, E10, A833, A1038, A956
  • ASTM E140 hardness conversions

Need Hardness Testing?

Tell us about your project and we'll get you a fast, no-nonsense quote.